DLUSER.DOC -- Changes from V4(4) to V5(4)
October 1981






























COPYRIGHT (C) 1976,1979,1982 BY
DIGITAL EQUIPMENT CORPORATION, MAYNARD, MASS.


THIS SOFTWARE IS FURNISHED UNDER A LICENSE AND MAY BE USED AND  COPIED
ONLY  IN  ACCORDANCE  WITH  THE  TERMS  OF  SUCH  LICENSE AND WITH THE
INCLUSION OF THE ABOVE COPYRIGHT NOTICE.  THIS SOFTWARE OR  ANY  OTHER
COPIES  THEREOF MAY NOT BE PROVIDED OR OTHERWISE MADE AVAILABLE TO ANY
OTHER PERSON.  NO TITLE TO AND OWNERSHIP OF  THE  SOFTWARE  IS  HEREBY
TRANSFERRED.

THE INFORMATION IN THIS SOFTWARE IS SUBJECT TO CHANGE  WITHOUT  NOTICE
AND  SHOULD  NOT  BE  CONSTRUED  AS  A COMMITMENT BY DIGITAL EQUIPMENT
CORPORATION.

DIGITAL ASSUMES NO RESPONSIBILITY FOR THE USE OR  RELIABILITY  OF  ITS
SOFTWARE ON EQUIPMENT WHICH IS NOT SUPPLIED BY DIGITAL.

DLU5.DOC                                                        Page 2


DLUSER.DOC -- Changes from V4(4) to V5(4)
October 1981



1.0  SUMMARY

DLUSER is a program which obtains identifying information  about  each
directory  on  a system and places it in a file.  The program can then
use this file to create the same directories later, in the event of  a
system rebuild.

DLUSER version 5(4) runs on Release 5 of TOPS-20.

DLUSER does not depend on any other software during its execution.

DLUSER is documented in  the  TOPS-20  Operator's  Guide  and  TOPS-20
System Manager's Guide.



2.0  EXTERNAL CHANGES

None.



3.0  KNOWN BUGS AND DEFICIENCIES

None.



4.0  INSTALLATION INSTRUCTIONS


4.1  Files Needed to Run DLUSER

DLUSER consists of one file, DLUSER.EXE.


4.2  Instructions for Loading and Installing DLUSER

Mount the tape labeled  Installation  Tape  on  MTA0:   and  type  the
following commands:

     SKIP MTA0:5 FILES
     R DUMPER
     TAPE MTA0:
     REWIND
     DENSITY 1600-BPI
     SKIP 1
     RESTORE <*>DLUSER.EXE (TO) SYS:*.*.-1
     REWIND

DLU5.DOC                                                        Page 3


4.3  Files Needed to Build DLUSER

DLUSER is built from the following file:

     DLUSER.MAC

In addition, the following files must be in SYS:

     MACREL.REL
     MACSYM.UNV
     MONSYM.UNV


4.4  Instructions for Building DLUSER

Mount the tape labeled  Distribution  Tape  on  MTA0:   and  type  the
following commands:

     R DUMPER
     TAPE MTA0:
     REWIND
     DENSITY 1600-BPI
     SKIP 1
     RESTORE <*>*.*.* (TO) <self>*.*.*
     REWIND
     ^C
     SUBMIT DLUSER.CTL/TIME/UNIQ:0/REST



5.0  INTERNAL changes

Refer to DLUSER.TCO for detailed information of changes to DLUSER.



6.0  SUGGESTIONS

None.



[End of DLU5.DOC]