SETSPD.DOC -- Changes from V4(15) to V5(25) October 1981 COPYRIGHT (C) 1978,1980,1982 BY DIGITAL EQUIPMENT CORPORATION, MAYNARD, MASS. THIS SOFTWARE IS FURNISHED UNDER A LICENSE AND MAY BE USED AND COPIED ONLY IN ACCORDANCE WITH THE TERMS OF SUCH LICENSE AND WITH THE INCLUSION OF THE ABOVE COPYRIGHT NOTICE. THIS SOFTWARE OR ANY OTHER COPIES THEREOF MAY NOT BE PROVIDED OR OTHERWISE MADE AVAILABLE TO ANY OTHER PERSON. NO TITLE TO AND OWNERSHIP OF THE SOFTWARE IS HEREBY TRANSFERRED. THE INFORMATION IN THIS SOFTWARE IS SUBJECT TO CHANGE WITHOUT NOTICE AND SHOULD NOT BE CONSTRUED AS A COMMITMENT BY DIGITAL EQUIPMENT CORPORATION. DIGITAL ASSUMES NO RESPONSIBILITY FOR THE USE OR RELIABILITY OF ITS SOFTWARE ON EQUIPMENT WHICH IS NOT SUPPLIED BY DIGITAL. STP5.DOC Page 2 SETSPD.DOC -- Changes from V4(15) to V5(25) October 1981 1.0 SUMMARY 5-SETSPD is a privileged system program which processes the 5-CONFIG.CMD file and, in so doing, sets many initial parameters about the system such as: initial line speeds, system logical names, and magtape logical to physical correspondences. 5-SETSPD version 5(15) runs only on Release 5 of TOPS-20. 5-SETSPD depends on the file PS:<SYSTEM>5-CONFIG.CMD. 2.0 EXTERNAL CHANGES None. 3.0 KNOWN BUGS AND DEFICIENCIES None. 4.0 INSTALLATION INSTRUCTIONS 4.1 Files Needed to Run 5-SETSPD 5-SETSPD consists of one file, 5-SETSPD.EXE and it reads the command file PS:<SYSTEM>5-CONFIG.CMD. 4.2 Instructions for Loading and Installing SETSPD Mount the tape labeled Installation Tape on MTA0: and type the following commands: SKIP MTA0:5 FILES R DUMPER TAPE MTA0: REWIND DENSITY 1600-BPI RESTORE <*>5-SETSPD.EXE (TO) SYSTEM:*.*.-1 REWIND ^C STP5.DOC Page 3 4.3 Files Needed to Build SETSPD 5-SETSPD is built from the following files: SETSPD.MAC SERCOD.UNV SERCOD.REL In addition, the following files must be on SYS: MACREL.REL MACSYM.UNV MONSYM.UNV 4.4 Instructions for Building SETSPD Mount the tape labeled Distribution Tape on MTA0: and type the following commands: R DUMPER TAPE MTA0: REWIND DENSITY 1600-BPI SKIP 1 RESTORE <*>*.*.* (TO) <self>*.*.* REWIND ^C SUBMIT SETSPD.CTL/TIME/UNIQ:0/REST The command file PS:<SYSTEM>5-CONFIG.CMD is produced by using EDIT and typing in the appropriate commands. 4.5 Special Considerations SETSPD is run automatically by the monitor when it is started and whenever one of the front end PDP11's is reloaded. It need not however be run under timesharing. 5.0 INTERNAL CHANGES Refer to SETSPD.TCO for detailed information about changes. 6.0 SUGGESTIONS None. [End of STP5.DOC]