M 1 6 3 8 T A U P I C O B I R D 9 FUJITSU NO MORE PRODUCED Native| Translation ------+-----+-----+----- Form 3.5"/SLIMLINE Cylinders 6189| 4982| | Capacity form/unform 2560/ MB Heads 4| 16| | Seek time / track 11.0/ 3.0 ms Sector/track | 63| | Controller IDE / ATA2 FAST/ENHA Precompensation Cache/Buffer 128 KB FIFO BUFFER Landing Zone Data transfer rate 7.700 MB/S int Bytes/Sector 512 16.700 MB/S ext PIO4 Recording method PR4ML operating | non-operating -------------+-------------- Supply voltage 5/12 V Temperature *C 5 55 | -40 60 Power: sleep 1.1 W Humidity % 8 80 | 5 95 standby W Altitude km -0.300 3.000| -0.300 12.000 idle W Shock g 5 | 75 seek W Rotation RPM 5400 read/write W Acoustic dBA 35 spin-up W ECC Bit SMART MTBF h 500000 Warranty Month Lift/Lock/Park YES Certificates ********************************************************************** L A Y O U T ********************************************************************** FUJITSU M163X/162XTAU JUMPER SETTING Jumper +Power-----2-6----------------------+ |xxxxxxxx ooo ooooooooo oooooooooo | |XXXXXXXX ooo oooooooooooooooooooo | |1 1 5 | +---------------Interface-----------+ ********************************************************************** J U M P E R S ********************************************************************** FUJITSU M163X/162XTAU JUMPER SETTING Jumper Setting ============== 2 6 X o o X o o MASTER (default) 1 5 2 6 o X o o X o SLAVE 1 5 2 6 xxx o o o o CABLE SELECT Cable Select Mode gives an alternative method 1 5 by which the drive may be set to MASTER or SLAVE. A special cable is needed to implement this feature and ahould only be used by BOTH drives. ********************************************************************** I N S T A L L ********************************************************************** FUJITSU M163X/162XTAU JUMPER SETTING Notes On Installation ===================== Grounding --------- Sufficient grounding will be provided for correct operation when the drive is screwed into an electrically grounded frame. Orientation ----------- The drive may be installed in one of three orientations; PCA down or on either edge. horizontally vertically +-----------------+ +--+ +--+ +------------------+ | | | +-----+ +-----+ | | | x | | | | | | | | x+----------------+x +-+-----------------+-+ | | | | | | ||x x|| +---------------------+ | | | | | | || x x || | | | | | | || x x || x x | | | | | | || x x || +------x------x-------+ | +-----+ +-----+ | || xx || +-+------x--x-------+-+ +--+ +--+ || x x || | xx | || x x || | x x | || x x || +---x--------x----+ |x x| x x x++----------------++x UNACCEPTABLE! UNACCEPTABLE! Never install PC board on the Top! Cooling ------- Allow space above and below the drive to provide for adequate air flow. Fan cooling is recommended. The disk enclosure temperature, measured at top center, should never exceed 60*C. Mounting screw fixing --------------------- When the mounting screw holes on the side of the drive are used, then use only the two pairs of outer holes. Do not use the center hole in conjunction with only one of the outer holes. The screw must not penetrate the drive. Screws: 6-32UNC